Clarification of Rule Specifics Re: Plafit State Titles

General Discussion, Race Reports & Results, for More 'Scale Related' Model Cars.
User avatar
stoo23
Posts: 1006
Joined: Mon Feb 02, 2009 8:15 am
Location: Berkeley Vale, NSW

Clarification of Rule Specifics Re: Plafit State Titles

Postby stoo23 » Tue Nov 08, 2011 12:53 pm

Please understand that I am NOT trying to be a 'Pain', just simply wanting to understand Exactly what Rules we will be running under at the forthcoming NSW Plafit State Titles regarding certain specific areas.

As was 'noted' by the reply to the other thread concerning Group C specifically,..apart from the arguably arbitrary exclusion of the SLPJ chassis, are the rules for this class (Other than that Exclusion), the same as the APC Group C rules?
With the obvious exclusion of required Body and car weight etc as compared too the Hard Body rules.

I understand (I Hope), that the 1/24th CanAm/Classics will Not be limited to the APC spec' regarding 'Spur' width or 'Polar Length' in Plafit racer terminology.

In regard to the 1/32 Modern GT rules exactly What set of rules will we be racing under, specifically regarding Ride Height and Car weight in the two Divisions.
Will Moslers with Lexan or Lightened versions be legal and if So,..Will they be running the Extra required Weight Placed High under the Roof to compensate as required at the APC?

Thanks in advance.

User avatar
stoo23
Posts: 1006
Joined: Mon Feb 02, 2009 8:15 am
Location: Berkeley Vale, NSW

Re: Clarification of Rule Specifics Re: Plafit State Titles

Postby stoo23 » Sat Nov 19, 2011 1:27 am

As can be seen, there has been No 'Official' reply, but it would seem the 2009 Qld' Plafit Rule set (as we Have previously been running under at HSC) is to be used.

Well atleast I Hope it is,.. ;) :lol: